089-600 富士胶片彩色复印机ApeosC7070/C6570/C5570/C4570/C3570/C3070/C2570故障代码

216 |

0 | 2024-03-16 16:08:14 | 显示全部楼层 |阅读模式

故障代码查询
设备分类:	复印机 » 富士胶片复印机 » Apeos C7070 / C6570 / C5570 / C4570 / C3570 / C3070
故障代码:	089-600
故障解释:	RC Sample Lateral Fail-A1
故障原因:	There is an error with K fast scan position that is used as a reference during A1 (fine adjustment pattern) and C patch detection. (This is a hidden failure. The Color Regi Spec cannot be guaranteed and Data is only recorded in history.) 1 (High) 089-313, 089-314, 089-316, 089-317 IReCT Error Fail 2 089-674, 089-675, 089-676 ReC LED Fail 3 089-677, 089-678, 089-679 ReC Thresh Hold Fail 4 089-623, 089-673, 089-629 Vsout Stability Fail 5 089-616 RC Data Over Flow Fail 6 089-604, 089-606, 089-607, 089-609, 089-610, 089-612, 089-613, 089-615 RC Sample Block Fail-B 7 089-601, 089-603 RC Sample Block Fail-A1 8 089-600 RC Sample Lateral Fail-A1 9 089-661, 089-664 RC Sample Block Fail-L 10 (Low) 089-617 RC Data Over Range Fail
故障排查:	Check the installation status of the IBT Belt. Is the IBT Belt installed properly? Y N Install the IBT Belt properly. After the installation, go to the Diag mode and perform DC675 Registration Control Setup Cycle (ADJ 18.1.5) then DC937 Procon On Print (ADJ 18.1.11) in sequence. Replace the IBT Belt Assembly (PL 6.1, PL 6.2). After replacement, go to the Diag mode and perform DC675 Registration Control Setup Cycle (ADJ 18.1.5) then DC937 Procon On Print (ADJ 18.1.11) in sequence.
说明备注:	-