故障代码查询
| 设备分类: |
复印机 » 富士胶片复印机 » Apeos C7070 / C6570 / C5570 / C4570 / C3570 / C3070 |
| 故障代码: |
089-603 |
| 故障解释: |
RC Sample Block Fail-A1-Out |
| 故障原因: |
During the A1 (fine adjustment pattern) and C patch detection, the patch at the Front ReC Sensor did not satisfy the defined number of valid sample blocks. (This is a hidden failure. The Color Regi Spec cannot be guaranteed and Data is only recorded in history.) |
| 故障排查: |
Check the Front ReC Sensor for contamination at the detection section, disconnected connector, open circuit, short circuit, and poor contact.
If no problem is found, replace the ReC/ADC Sensor Assembly (PL 6.1, PL 6.2). After replacement, go to the Diag mode and perform DC675 Registration Control Setup Cycle (ADJ 18.1.5) then DC937 Procon On Print (ADJ 18.1.11) in sequence. |
| 说明备注: |
- |
注册或关注公众号后查看更多内容
您需要 登录 才可以下载或查看，没有账号？我要加入
×
长按二维码识别并关注，查询更多信息......
更多案例请查看下方相关推荐 |
|
